[Elecraft] K3SYN3 with and without shielding

[Brett Howard]

Couldn't hurt as its going to have all the latest mods.

That is a stiffener and not really a "shield". Go to the mod kits and parts
section on the elecraft website and you can read the installation
instructions on that stiffener and even buy one to upgrade your other synth
if you wish...

~Brett (N7MG)

On Jun 23, 2010 7:04 AM, "Sverre Holm (LA3ZA)" <LA3ZA at nrrl.no> wrote:
>
> I am about to install the second receiver in the K3. I now have two
> synthesizers, the old no 1 which has been made up to date with a
paralleled
> resistor (
> http://www.elecraft.com/K3/mods/KSYN3%20DDS%20Gain%20Modification.pdfKSYN3
> DDS Gain Modification ) and which does not have any shield. Then I have a
> new one with a shield which is several mm thick and covers most of the
PCB.
>
> I would guess the shield is there for a purpose, so is it advisable that I
> swap the synthesizers and use the shielded one as no 1, which is also used
> for transmission I presume?
>
>
> Sverre
>
> -----
> Sverre, LA3ZA
>
> K2 #2198, K3 #3391
> http://www.qslnet.de/member/la3za/K2/mod.html LA3ZA Unofficial Guide to K2
> modifications
> --
> View this message in context:
http://elecraft.365791.n2.nabble.com/K3SYN3-with-and-without-shielding-tp5213399p5213399.html
> Sent from the [K3] mailing list archive at Nabble.com.
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html