[Elecraft] K3 Beta Firmware Rev. 4.03: "CW+" mode (Ultra-fast break-in; VOX-CW up to 100 WPM)

[Julian, G4ILO]

wayne burdick wrote:
> 
> K3 beta-test firmware revision 4.02 (with DSP rev. 2.60) is now  
> available. See full release notes below.
> 
> [snip]
> 
> * 75 BAUD (100 WPM) RTTY SUPPORT: The built-in
> encoder/decoder (DATA/FSK-D) now supports both 45 and
> 75 baud. To select the desired rate, hold the DATA MD
> switch, then rotate VFO A.
> 

Has anyone tried the built-in RTTY? When I tried it, I could copy other
stations perfectly but no-one would come back to me. Eventually I set up
another receiver to see if I could copy it and I found I had to reverse the
sideband before I could decode the text.

-----
Julian, G4ILO. K2 #392  K3 #222.
* G4ILO's Shack - http://www.g4ilo.com
* KComm - http://www.g4ilo.com/kcomm.html
* KTune - http://www.g4ilo.com/ktune.html

-- 
View this message in context: http://elecraft.365791.n2.nabble.com/K3-Beta-Firmware-Rev-3-57-Synchronous-AM-Detection-AM-S-misc-improvements-tp3983997p5179639.html
Sent from the [K3] mailing list archive at Nabble.com.