[Elecraft] K3 - Help Needed in Chicago Area

[N8XPQ]

Chuck,
 
Have you made sure that your synthesizer has been configured properly? The
instructions for this can be found on page 49 in the owners manual.

Synthesizer
This procedure is normally done at assembly time
or by the factory.
• Hold CONFIG and find the CONFIG:VCO
MD menu entry. Set the parameter fully
clockwise to CAL. Exit the menu. The
synthesizer will be tested and calibrated.
• To calibrate the 2nd synthesizer (for the sub
receiver), locate CONFIG:VCO MD and set
the parameter to CAL, tap SUB to turn on the
SUB icon, then exit the menu.

Possibly this may help.

Good luck,

Mike N8XPQ
-- 
View this message in context: http://elecraft.365791.n2.nabble.com/K3-Help-Needed-in-Chicago-Area-tp5149914p5153730.html
Sent from the [K3] mailing list archive at Nabble.com.