[Elecraft] XV50 cooling

[Eric]

I have a late-model xv144 with holes in both top and bottom panels, connected to k3 with milliwatt drive. It runs excessively hot at 10w out in digital mode EME when used one minute on one minute off,  so i dont think  just getting new panels will help you.  I use a small muffin fan blowing air underneath with the xv-144 up on the optional tilt stand and this simple solution works great. 

I also use an xv-432 for eme at 10w but its internal fan keeps it cool. 

Perhaps if enough people request a retrofit kit with an internal fan for the xv-50 and xv-144 Elecraft would consider it.  I'd pony up. The fan could attach inside the top panel. 

73

Eric WD6DBM 

Sent from my ePhone (I wish)