[Elecraft] DIGOUT0

[Joe Subich, W4TV]

The information is in the manual.

Page 18:

 > DIGOUT0 (See Transverter Control)

Page 19 (Transverter Control):

 > With KIO3 set to TRN or HF-TRN, the DIGOUT0 line (ACC, pin 6)
 > will output 0 V when low power mode is selected for the current
 > transverter band (CONFIG:XVn PWR). At all other times, DIGOUT0
 > will be floating (Hi-Z).

With a pull-up resistor to +5 or +12V, DIGOUT0 will normally be
high and will go low ("ground") when a transverter band is selected.

73,

    ... Joe, W4TV


On 7/29/2010 1:03 PM, Richard Dowling wrote:
> Yesterday's post regarding using DIGOUT1 peaked my interest so I
> consulted the manuals and schematic and there is a hardware DIGOUT0
> but no reference as to what it is for or how to control it.  My radio
> was somewhere else so haven't had a chance to look in the menu to see
> if it is there in fact.
>
> 73
> Richard
> KL0DR
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>