[Elecraft] K3 #2913 Stuck with MCU L D on the Display

[Dick Dievendorff]

Remove K3 power by pulling the power plug. Wait about 30 seconds. Shut down the K3 Utility. Plug the radio back in, and turn it on with the power button. Then start the K3 Utility again and load firmware

Dick, K6KR

Sent from my iPhone

On Jul 29, 2010, at 9:21 AM, ANTNEE N3ANT <n3ant at live.com> wrote:

> 
> Hello All, I was updating my K3/100 with MCU 4.03 / DSP 2.60 when It stop and
> reported a failure with the update...The screen on the K3 reads MCU L D and
> the TX redlight is blinking. The K3 Utility reads the time and after the
> time It reads(sent ";" at 38400 bps) I tried to and reload the K3 Utility
> and the Win2K/XP/2000/Vista/Win7 (32 and 64 bits) Driver for the USB/Serial
> cable...No Luck ! ! ! How would I reset the K3 to get out of the MCU L D on
> the screen ?
> 
> Thanks for any Help ! ! !
> 
> Antnee N3ANT
> 
> K3/100 #2913
> -- 
> View this message in context: http://elecraft.365791.n2.nabble.com/K3-2913-Stuck-with-MCU-L-D-on-the-Display-tp5347542p5347542.html
> Sent from the Elecraft mailing list archive at Nabble.com.
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html