[Elecraft] continuous relay click in RX ANT IN

[Jorge Diez - CX6VM]

Thanks Tom,

I have the later version, will check with relays it have.

Will install it, taking care of the amp relay control. I have the diagram to
connect it right.

Thanks !

73,
Jorge
CX6VM/CW5W

-----Mensaje original-----
De: Tom W8JI [mailto:w8ji at w8ji.com] 
Enviado el: Martes, 13 de Julio de 2010 11:37 a.m.
Para: Jorge Diez - CX6VM; 'Elecraft Reflector'
Asunto: Re: [Elecraft] continuous relay click in RX ANT IN

> Seems is similar to this made from ICE, at least will add extra protection

> to the K3, what do you think?
>
> Or it will decrease the RX signals I can receive in the K3?

As far as I know that unit uses reed relays, and should have no detectable 
loss. I think there might be two models of that, but I have only seen a reed

relay  version.

The advantage of the one I saw is the low loss and no signal distortion 
using relays. You must run the amplifier relay control through it to be sure

the protection sequence is correct.

73 Tom