[Elecraft] K2: Heil mic configurations

[Don Wilhelm]

Jim,

"It all depends".  If you are using the K2/100, then the RF gain through 
the TX chain is usually sufficient for the HC-4 and HC-5 elements.  If 
you are using the K2/10, then a microphone amplifier to make up for the 
lower output of those mic elements is prudent.  The respomse on the 
lower bands will be sufficient, but for use on 15 meters and above, the 
preamp may be needed.

Yes, you can configure the K2 microphone configuration header to use 
most any microphone pinout.  But you will need to procure or make an 
adapter cable for any microphone that uses other than an 8 pin Fostor 
connector.

See the KSB2 manual for the microphone configuration settings - it does 
not specify the Heil microphones, so wire it for the Heil adapter that 
you are using.

73,
Don W3FPR

Jim Faulkner wrote:
> I'm sure this topic has been covered before. I would like to use my Heil
> BM-10-5 boomset and HMM-Y mic with my K2.
>
> The HMM has both HC-4 and HC-5 elements, and an 8-pin connector
> configured for Yaesu radios. The BM-10-5 has the HC-5 element, and a
> 1/8" mono phone plug. I don't have an adapter cable.
>
> I thought I remembered that a small amplifier had to be used with these
> elements, but I can't find any reference to it. Do I need that, or can I
> easily set up the mic configuration block to mimic another
> manufacturer's settings? 
>
> Thanks in advance. I hope my SPAM filter doesn't reply to the entire
> list if someone replies, if it does, I apologize in advance (I'm not too
> bright sometimes, in fact my DVD player still flashes 12:00!).
>
> Jim  KO5V
> Sandia Park, NM
> K2 #5149
>
>  
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>
>