[Elecraft] K3 Disabling VOX on CW.

[W6NEK]

Hello Ian,
While in CW mode just "press and hold" the VOX function Off (press left side 
of Band Select Button in upper left corner of K3).  With the VOX function 
Off in CW mode the PTT function will be enabled which will allow you to use 
your foot switch for Tx/Rx change over.

73,
Frank - W6NEK

----- Original Message ----- 
From: "G0AFH" <g0afh at g0afh.com>
To: <Elecraft at mailman.qth.net>
Sent: Wednesday, July 07, 2010 1:53 PM
Subject: [Elecraft] K3 Disabling VOX on CW.


> Hi
>
> I would like to disable VOX in CW mode so that when I touch the key the
> rig does not go into transmit. Is this possible?
>
> My primary use for the K3 is to drive transverters and I use manual
> tx/rx change over or a foot switch - even on cw.
>
> 73
> Ian
> G0AFH.