[Elecraft] K2 rx alignment problem

[nick thomas]

Greetings-

I am having a problem understanding what I did wrong after I aligned the
filters in my K2 using spectrogram.

The basic problem is this; the indicated receive frequency for a cw signal
is reading 890 to 940 hertz too low. I do not even have enough RIT to make
up the difference.

I have confirmed that my transmitted signal agrees with the indicated
frequency on my VFO. So tx is confirmed transmiting at indicated frequency
on my VFO.

But for some reason the RX is way off.

What is the best course of action to tighten up the rx so that the indicated
rx frequency is again correct?

-- 
-Nick NT1A