[Elecraft] K3 and RigExpert question - problem solved

[David F. Reed]

Don,

Thanks for the suggestion, the rear mic input had the needed 
sensitivity; works great now.

73 de Dave, W5SV

On 7/2/10 1:36 PM, Don Wilhelm wrote:
> Dave,
>
> Which RigExpert do you have and how do you have it hooked to the K3.
> If you are connecting to LINE IN, that input requires a higher input 
> level than the microphone input, and you will have to turn the output 
> knob on the RigExpert almost all the way up.
>
> 73,
> Don W3FPR
>
> David F. Reed wrote:
>> Hi folks;
>>
>> I am having a problem getting digital modes going using a RigExpert 
>> with my K3.
>>
>> I know I have everything hooked up right, as RX is fine, TX happens, 
>> but no power out.  I know the audio is coming to line in as I can 
>> hear it with the monitor turned up all the way.
>>
>> What seems to be the problem is too low a sensitivity on the K3 input 
>> side (MIC gain all the way up in digital mode), as the RigExpert 
>> works fine with my TS-480 and my IC-7800; I only see this on my K3.
>>
>> Any suggestions or help would be greatly appreciated.
>>