[Elecraft] K2 Tilt Bale Installation

[NQ3RP]

Mount the plastic holders to the bottom first thing.  Next take a loop of
strong twine and tie it tight around the legs of of the bail so the loop is
about tight but not quit.  Take a short screwdriver and place it in between
the twine loops between the legs.  Start twisting the the loop by turning
the screwdriver in a circle.  In a short time the tightening of the twine
loop will pull the legs in enough to insert them in the mounting.  Be VERY
careful on releasing the screw driver by untwisting so that it doesn't get
away from you.


John
NQ3RP  
-- 
View this message in context: http://elecraft.365791.n2.nabble.com/K2-Tilt-Bale-Installation-tp5226608p5245656.html
Sent from the [K2] mailing list archive at Nabble.com.