[Elecraft] K2 parts question

[Don Wilhelm]

LS,

Small capacitors are marked in several ways it may have the actual value 
expressed as a decimal, such as 2.2 or there may be an "R" in place of 
the decimal point, such as 2R2.  It is all the same.  How they are 
marked depends on the manufacturer, and is subject to change from time 
to time.

C33 can be 2 pF, 2.2 pF (also marked with 2R2 - same thing)
C22 can be 2.7 pF, 3 pF or 3.3 pF - the decimal point may be replaced 
with an R in any of these.

It seems you have the correct capacitors located.

73,
Don W3FPR

lstavenhagen wrote:
> Hi all,
>
> Ok, I've called the parts inventory good, except two parts for the RF board
> that I couldn't quite figure out and made a guess that they were right. But
> not sure:
>
> C33 - this part is listed as a 2.2pf cap which should have a label "2R2 or
> "2" according to the parts list. I could only find a small disk cap with
> what looked like "2.2" on it, not "2R2" or "2". Is that the correct part?
>
> C22 - the Value column just has "pf)", the description says it should be
> labelled "2R7", "3", "3.3", or "3R3". In the end I could only find a small
> blue cap with "2.7" on it leftover and assumed this was C22. Is this right?
> The schematic shows a 3.3pf cap here...
>
> What say ye folks?
>
> Thanks es 73,
>
> LS
>   
> ------------------------------------------------------------------------
>
>
> No virus found in this incoming message.
> Checked by AVG - www.avg.com 
> Version: 9.0.733 / Virus Database: 271.1.1/2651 - Release Date: 01/28/10 02:36:00
>
>