[Elecraft] NR adjust on sub?

[Joe Subich, W4TV]

Don, 

>From the new firmware release notes: 

> Other new features and improvements:
> 
> * NR (NOISE REDUCTION) ON/OFF: This is now saved
> on a per-band/per-receiver basis (same as NB). NR ADJ
> (noise reduction setting) is stored independently for 
> each mode.

I haven't loaded the beta firmware but that says it 
should be possible to set different NR and NB values 
for each receiver. 

73, 

   ... Joe, W4TV 
 


> -----Original Message-----
> From: elecraft-bounces at mailman.qth.net 
> [mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Don Wilhelm
> Sent: Tuesday, January 26, 2010 12:38 AM
> To: Jim Miller
> Cc: Elecraft Reflector
> Subject: Re: [Elecraft] NR adjust on sub?
> 
> 
> Jim,
> 
> Contrary to what the manual says, the state of NR is the same 
> for both 
> the Main RX and the SUB.
> Wayne has indicated that the manual is not correct in this particular 
> aspect and will be corrected in the next manual revision.
> 
> 73,
> Don W3FPR.
> 
> Jim Miller wrote:
> > I've activated Bset but when I hold the NR button I don't 
> get a Fx-x 
> > indication for setting the Sub NR.
> >
> > Didn't see anything in the manual or scanning throught the Config 
> > settings.
> >
> > How is this done?
> >
> > tnx
> >
> > jim ab3cv (sub newbie)
> >   
> >
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html