[Elecraft] K2 help!! Fault pulling my hair out

[G6YAQ Frank]

Hello from UK,
I have a problem with my K2 s/no 2390,a long story but the short version is
that it was ok when I aquired it 12 months ago but could not get 40 mtrs
band,after afew emails from our helpful friends I found that D19 in the sec
menu was not switched on ,I did this and all bands were working okon
receive.
I then decided to put rear bott panel back on along with the pa transistors
checking for shorts etc, (taken off previous to check for dry joints) all
other modules were re installed ie k60 xv and 160mtr units .On switching K2
back on nothing at all but af noise ,no signals at all on any of the bands
,display and all controls seem to be working correctly,Ithought I may have
had a dry joint appear somewhere so rear panel off again to look could see
nothing .I checked and resoldered all pcb joints on the main board and still
dead as a do do!!(not hi) Thinking would a reset on the K2 help?
Can anybody out there help as don't know what to do next will even consider
sending to some one who can fix or help local in the UK m/cr,lancs area, and
as a last resort to the USA ,or Elecraft if it requires it.
Tnx for reading,Frank
-- 
View this message in context: http://n2.nabble.com/K2-help-Fault-pulling-my-hair-out-tp4449880p4449880.html
Sent from the Elecraft mailing list archive at Nabble.com.