[Elecraft] Re： W2 assembly

[Johnny Siu]

Hello Jim,

I use a very coarse sand paper to remove the paint.  In K2, Elecraft did mask off some of the contact areas.  I just don't know why they don't do that on W2.  I suppose the cost to do that should be minimal to Elecraft.

cheers,

Johnny VR2XMC



----- 郵件原件 ----
寄件人﹕ Jim Spears <n1nk at cox.net>
收件人﹕ elecraft at mailman.qth.net
傳送日期﹕ 2010/1/21 (四) 10:53:13 PM
主題： [Elecraft] W2 assembly

I am assembling a W2 wattmeter.  So far so good.  Removing the baked on
paint for electrical conductivity at the holes is turning out to be a real
pain.  Does anyone have a tip for an efficient method for doing this?  So
far the best I have found is scratching with the tip of a knife.  Perhaps
Elecraft could have this area masked off during the paint process.



Jim/N1NK

K3 2295


      Yahoo!香港提供網上安全攻略，教你如何防範黑客! 請前往 http://hk.promo.yahoo.com/security/ 了解更多!