[Elecraft] K3 ESSB macro

[Greg]

Ooops....no bug.  Radio was in CW mode.  Duh!

The first line show ESSB off, second line shows ESSB on.

IC\x80\xA8\x94\x90\x80;

IC\x80\xA8\x94\xB0\x80;

So the status of Byte D tells you the status of ESSB.

73
Greg



On 1/17/2010 4:05 PM, Greg wrote:
> When looking at this Barry I thought maybe you could read the status 
> of the "+" icon on the LCD.  That is supposed to be on if ESSB is on.  
> I think a bug got into the FW where the icon is no longer showing when 
> in ESSB.
>
> This is from the current Programmer's manual...
>
> IC * (Misc. Icons and Status; GET only)
> RSP format: ICabcde; where abcde are ASCII characters (Byte in Table 4 
> below) used as collections flags (Bit
> in table). Each flag represents the status of an LCD icon and/or 
> specific transceiver function.
> Some functions whose status is indicated by IC command flags can be 
> controlled using emulation commands. For
> example, the K3 can be put into TX TEST by sending SWH18. The 
> condition can be verified at any time using the
> IC command (byte a, bit 5). Another example: ESSB (extended SSB) can 
> be turned on/off using an MN (menu)
> command, followed by SWT11, simulating a tap of 1 on the keypad. 
> Again, IC can be used to verify the present
> state (byte d, bit 5).
>
>
> 73
> Greg
> AB7R
>
>
>
>
>
> On 1/17/2010 12:35 PM, Barry N1EU wrote:
>> Can someone please confirm:  it is possible to toggle the TX ESSB on/off
>> value via macro (mn096;swt11;mn255;) but it is impossible to set it to a
>> known value of "on" or "off" ?
>>
>> Thanks/73,
>> Barry N1EU
>>    
>>
>>
>>
>> No virus found in this incoming message.
>> Checked by AVG -www.avg.com
>> Version: 8.5.432 / Virus Database: 270.14.147/2628 - Release Date: 01/17/10 07:35:00
>>
>>    
>
>
>
> No virus found in this incoming message.
> Checked by AVG - www.avg.com
> Version: 8.5.432 / Virus Database: 270.14.147/2628 - Release Date: 01/17/10 07:35:00
>
>