[Elecraft] K3: MH2 Mic

[NZ0T]

Here are the settings I use - worked out with a group on 1.947 that is very
"up" on all that SSB stuff.

1    +4
2    +1
3    +1
4    +2
5    +2
6      0
7      0
8      0

Seems to need some help in the lower frequencies.  I also use a RatShack
studio mic and it seems to need less highs also but not any bass boost.  I
suggest you find a quiet frequency, a group of friends and work it out over
the air.

73 Bill NZ0T

Don Wilhelm-4 wrote:
> 
> Phil,
> 
> Adjust the mic gain until you have 5 to 7 bars indicated on the ALC 
> meter, then add compression as you desire.
> You can use the monitor to listen on the headphones (just remember to 
> turn the monitor back down to zero to use the speaker(s) or you will 
> have a lot of audio feedback).
> 
> 73,
> Don W3FPR
> 
> Phil Hystad wrote:
>> I just received the MH2 hand mic in the mail today for my rather new K3. 
>> Can someone suggest some starting "settings" for mic gain and
>> compression.  Right now, I have mic gain set to 5 and compression set to
>> 4 but I really do not know how it comes across over the air.  I could
>> monitor the signal but I would rather start off close to a good mix and
>> then diddle with it from there once I find someone close to monitor my
>> audio signal.
>>
>> Thanks,
>> 73, phil, K7PEH
>>   
>>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> 
> 

-- 
View this message in context: http://n2.nabble.com/K3-MH2-Mic-tp4372634p4385698.html
Sent from the Elecraft mailing list archive at Nabble.com.