[Elecraft] [K3] IF output

[srife at swbell.net]

	I was expecting to hear a carrier, but after I thought about it that
can't be the case. 

	With the IF connected to the Subreceiver I can tune around either
side of 8215 and hear QSO's. I have to have the Preamp on by I can hear
them. Would that be considered adequate? I have done the IF mod and used a
15K resistor in place of the original. I actually had a 10K & a 15K and Gary
Surrency said either one of them would work. So error on the side of caution
I used the 15K.


Stan Rife 
W5EWA 



-----Original Message-----
From: Don Wilhelm [mailto:w3fpr at embarqmail.com] 
Sent: Tuesday, January 12, 2010 4:27 PM
To: srife at swbell.net
Cc: elecraft at mailman.qth.net
Subject: Re: [Elecraft] [K3] IF output

Stan,

I should think you can - although you will have to be careful to listen 
to the correct audio channel - it would be wierd to hear the real K3 
received signal in one ear and the sub receiving the IF output signal in 
the other.

73,
Don W3FPR

srife at swbell.net wrote:
> Don, can I use the SUB receiver in the K3 to do that? I have the KBPF3 in
the sub receiver.
>
>
> Stan Rife 
> W5EWA 
>   
>
No virus found in this incoming message.
Checked by AVG - www.avg.com 
Version: 9.0.725 / Virus Database: 270.14.136/2616 - Release Date: 01/12/10
01:35:00