[Elecraft] Panadapter Setup for K2 - Where can I read-up on this? Goos source for advice?

[Don Wilhelm]

Dean,

The plan for the P3 as I have heard it is to also support the K2 IF, and 
I cannot recall if the LP-PAN is available with an IF input to match the 
K2 IF.  You would need a buffer amplifier added to your K2 to bring the 
IF signal out.  There is a version of Jack Smith's Z10000 buffer 
amplifier kit just for that purpose.  Check 
http://www.cliftonlaboratories.com/z10000_buffer_amp.htm for more 
information.
You will also find on that same page that you can use a Softrock 
receiver to produce the panoramic display on a computer display rather 
than a P3 or LP-PAN if that less expensive alternative appeals to you.  
(I don't know how many SoftRock 6.2 boards Tony Parks has available, but 
you can ask).

73,
Don W3FPR

Dean wrote:
> I am looking for a source for good advice to set up a panadaper, software etc for the K2. Best to get/build, how to set it up etc.
>
> Thanks in advance for your help!
>
> Dean
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> ------------------------------------------------------------------------
>
>
> No virus found in this incoming message.
> Checked by AVG - www.avg.com 
> Version: 9.0.725 / Virus Database: 270.14.134/2613 - Release Date: 01/11/10 02:35:00
>
>