[Elecraft] [K3] KRX3 install

[Joe Planisky]

The most obvious question:  Did you set CONFIG:KRX3 to "Ant=bnc" or  
"Ant=Atu"? (as opposed to "not inSt")

73
--
Joe KB8AP

On Jan 10, 2010, at 5:58 PM, <srife at swbell.net> wrote:

> 	I've just finished installing a KRX3 with the KBPF3 and when I push
> the sub button it tells me "NO SUB". I have been through the menus  
> several
> times, setting up the filters and modes and bandwidths for the main  
> and the
> sub receiver but I still get the same error when I try to select the  
> sub
> receiver. I have also selected the KBPF3 for the sub receiver, but it
> doesn't ask me about setting up the KBPF3 for the sub. I assumed you  
> would
> have to tell it when to use the KBPF3 as with the other filters.  
> Maybe this
> is done automatically when going outside the amateur bands. I seem  
> to recall
> something about this.
>
> 	I'm sure I have missed something. Can someone help? This is the very
> first time I have installed something in the K3 (or the K2) that  
> didn't
> work.
>
> Still looking through the manual,
>
>
> Stan Rife
> W5EWA
>
>
>
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html