[Elecraft] K144XV and +TX signal on BNC?

[Alexandr Kobranov]

Hello friends,

I tried to look for below mentioned function (jumper settings) in 
144MHz module but in last rev of manual I missed or it is not there.
(yet?)

Are there any details about this possibility - to put +TX to centre 
pin of BNC output?

Thanks for info,

73!
Lexa, ok1dst
K3/10 #727



Dne 19.8.2009 23:20, Eric Swartz - WA6HHQ, Elecraft napsal(a):
> There is a jumper block that optionally allows the connection of a +5V
> signal onto the antenna connector during transmit. A maximum of 1 ma.
> is available.
>
> 73, eric WA6HHQ
>
> Alexandr Kobranov wrote:
>> Let me ask - was +TX signal (9-12V) on centre pin of BNC included in
>> future plan?
>> This "option" (one internal jumper at least) is very practical for
>> most of (in EU :-)) used transverter system control during FD etc.
>>
>> And thanks for all so big job with Kx, Px, ... development!!
>>
>> 73!
>> Lexa, ok1dst
>> K3/10 #727
>>
>