[Elecraft] K3 not communicating with PC

[Gary Smith]

Roger,

I think you may be experiencing the problem I had which I asked about 
yesterday
subject: Re: [Elecraft] K3 Firmware update question - k3fw3r68

Check your ports with the elecraft utility, I had the same kind of 
issue and I needed to find an open port that gave me 4800 bps.

I never had the problem before after an update to a new version. 
Perhaps you've just updated? Or perhaps your port is active to a 
different application using the port you had assigned in the utility 
at a prior time?

Gary
KA1J

> Hi all,
> 
> I can't work out why my K3 has stopped communicating with my PC. Besides 
> the K3 utility I'm using HRD. Up to now I've used the KUSB which has 
> worked fine, it was bought with K3 #191 at the same time.  I reinstalled 
> the drivers checked Baud rate (38400), swapped ports etc but still no go.
> 
> I then tried a standard RS232 instead, but still it does not work.   
> 
> What am I missing here? Any help would be appreciated (my email is set 
> to digest mode).
> 
> 73
> Roger  MW0IDX
> 
> K3 #191
> K2 #2724
> KX1 #416
> 
> 
> 
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>