[Elecraft] K3 output buffer modification

[James Sarte]

Hi Alan,

Unfortunately, I do not have a second receiver.  Is there a way I can test
output voltages with my meter - anything at all to just confirm that the
resistor is indeed working?

Anyway, the rig passed the smoke test upon turning on so that's a good start
right there.

James K2QI

On Wed, Jan 6, 2010 at 3:26 PM, Alan Bloom <alan at elecraft.com> wrote:

> If you have a second receiver, you could connect it to the K3 IF output.
> Tune the second receiver to 8.215 MHz and you should hear whatever the
> K3 is hearing at a similar signal level.  (About an S-unit lower with
> the K3 preamp off, one S-unit higher with preamp on.)
>
> Alan N1AL
>
>
-- 
73 de James K2QI