[Elecraft] W2 Firmware Suggestion

[Brian Broggie]

Hi, Bill!

The ability to save the Alarm state was added in rev 0.93 (rev 0.94 is 
the current rev).  You still need a pc to set it, but it will stay that 
way from then on.  The front panel "Sensor" button clears the Alarm 
message (flashing SWR LED's) and resets for the next high SWR condition. 
Please use the "Elecraft W2 Utility" program to update your W2's 
firmware and enjoy this feature.  If you are not familiar...

http://www.elecraft.com/software/W2/elecraft_w2_software.htm

73,
Brian, W6FVI
W2 Firmware Engineer
Elecraft, Inc.


Bill Miner wrote:
> With all the recent discussion about the W2 I decided to actually read the on-line manual and check the specs for my self.
>  
> Upon further reading I discovered that to set the SWR alarm feature it is necessary to have a PC connected and to set the alarm each time the unit is powered up.
>  
> If possible, it would be nice to be able to turn on the alarm feature from the front panel of the W2 and once set,  have the alarm enable in memory so that it was not necessary to do this every time the unit is power cycled..
>  
> OBTW I am very pleased with the current firmware load for the K3.  
>  
> Thanks & 73,
> Bill - K6WLM
> K3
> K2
> KX1
>
>
>       
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>
>