[Elecraft] DIY DSP Rev D

[Julian, G4ILO]

DaveL  G3TJP wrote:
> 
> Note, working with 0603 size SMT components is not a task to be undertaken
> lightly.  Considerable skill is needed to remove existing components and
> substitute the replacement values.
> 
I have very little experience with SMT components but I recall that I had to
remove a couple to do one of the earlier K3 mods. I just used two soldering
irons and applied them to both ends of the part at the same time and it was
off in a jiffy. MUCH easier than removing parts from thru-hole boards.

So is this really as difficult as people make out?

-----
Julian, G4ILO. K2 #392  K3 #222.
* G4ILO's Shack - http://www.g4ilo.com
* KComm - http://www.g4ilo.com/kcomm.html
* KTune - http://www.g4ilo.com/ktune.html

-- 
View this message in context: http://n2.nabble.com/DIY-DSP-Rev-D-tp4238315p4239293.html
Sent from the Elecraft mailing list archive at Nabble.com.