[Elecraft] Pre for the Rx ant only?

[WILLIS COOKE]

After (or before) activate bset and put the pre-amp where you want it, the switch off bset.  The preamp will stay on, but you only have the indication when you activate bset.
 Willis 'Cookie' Cooke 
K5EWJ 




________________________________
From: Gary Smith <Gary at ka1j.com>
To: elecraft at mailman.qth.net
Sent: Wed, February 24, 2010 3:42:22 PM
Subject: [Elecraft] Pre for the Rx ant only?

when I am using my Rx ant into the sub receiver, I click sub and then 
hold Rx-ANT till it says AUx. I have my beverage connected to the BNC 
port below ANT2.

If I want to have the K3 preamp on for this Rx antenna but not have 
it on for the Inverted L, how do I engage the second receiver so it 
alone has the preamp engaged? I don't want the noise from my transmit 
antenna amplified.

I am mostly working diversity.

Thanks,

Gary
KA1J
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html