[Elecraft] AFSK A not working, while DATA A is!?

[Joe Planisky]

Hi Frank.

Make sure the mark tone frequency your software is set up for matches  
the mark tone frequency the K3 is set for.  In AFSK-A mode, use the  
PITCH button (i.e. press and hold the SPOT button) to check and set  
the AFSK mark frequency.

See the section titled "Mark/Shift and Pitch Selection" on page 31 of  
the K3 Owners Manual.

73
--
Joe KB8AP



On Feb 10, 2010, at 10:11 AM, Frank R. Oppedijk wrote:

> ...so I tweaked the necessary controls on
> my K3 and on my PC soundcard. But no transmit output?! The PTT is
> asserted and the receiver is muted, but no transmit output and no
> monitor output. ...
> ... I found out that everything was
> working fine when I changed the DATA MD from AFSK A to DATA A!...
> Can anyone help me out? What setting or control can be the cause of  
> this?
>
> Thanks in advance,
>
> Frank PA4N
>