[Elecraft] Elecraft K3 utility - RS-232 port speed?

[Dick Dievendorff]

The K3 Utility finds the K3 at the speed it is set to (see the K3 CONFIG
menu, RS232).  

It does this by polling at all four of the supported K3 speeds.

During firmware load the K3 Utility changes the speed to 38400 bps and then
restores it to the original speed after a successful firmware load.

It's not described in great detail because you don't need to do anything to
pick any particular speed.

Dick, K6KR


-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of rrkrr
Sent: Sunday, February 07, 2010 3:44 PM
To: Elecraft Reflector
Subject: [Elecraft] Elecraft K3 utility - RS-232 port speed?

I have downloaded the Elecraft K3 utility and have it running on my
Ubuntu computer.  The utility communicates with the K3 and sees the
firmware version I presently have as 2.7.  Right now the serial port
speed on my computer is 9600 baud.  However, I can't find a recommended
port speed to use for the firmware upgrade in the K3 utility
documentation.  Can someone clue me in?

Bob K4ERR
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html