[Elecraft] K2 - Question on control board

[John Wingard]

I'm in the process of upgrading my K2/10 (SN 1057) to a K2/100. I am also finishing up the KAT100 tuner and have a question. The tuner instructions state to remove C44 from the K2 control board. I have a Revision A control board without a C44. It also states that if this is the case, a capacitor may have been soldered directly across R7. On my board, a resistor is installed at R7 (no capacitor). Do I leave R7 in or take it out? Incidentally, I did all of the Rev A to B mods a number of years ago, so this looks like the only thing left to check on the control board before proceeding.

Tnx de John, WB4GLJ