[Elecraft] muting audio on PSK

[Joe Subich, W4TV]

Paul,

Are you aware that the MON level is saved on a per mode
basis?  Did you check MON while in Data mode (assuming
you are using DATA A for PSK31)?

73,

    ... Joe, W4TV


On 12/22/2010 5:04 PM, Paul Milward wrote:
> tnx for all the responses
> I have a pair of stereo speakers connected to the back of the K3. I also have a
> Yamaha headset connected, both the speakers and headset are always active. This
> setup allows me to monitor from across the room and also to rapidly access the
> headset when necessary. Obviously I do not need audio for PSK. Received audio is
> easily silenced by setting audio gain to zero, but transmit audio is always
> present regardless of the Power setting. The MON=0 and the audio is produced in
> the k3 not the computer.
> I use a pair of stereo cables from the I/O on the back of the rig to the (audio)
> I/O on the laptop
>
>
>
>
> ________________________________
> From: Wes Stewart<n7ws at yahoo.com>
> To: elecraft reflector<elecraft at mailman.qth.net>; Paul Milward
> <nu4c at bellsouth.net>
> Sent: Wed, December 22, 2010 12:20:32 PM
> Subject: Re: [Elecraft] muting audio on PSK
>
> 1)  Are you sure it's coming out of the K3 and not the sound card?
>
> 2)  Does transmitter power affect it?
>
> Wes  N7WS
>
> --- On Wed, 12/22/10, Paul Milward<nu4c at bellsouth.net>  wrote:
>
>> From: Paul Milward<nu4c at bellsouth.net>
>> Subject: Re: [Elecraft] muting audio on PSK
>> To: "elecraft reflector"<elecraft at mailman.qth.net>
>> Date: Wednesday, December 22, 2010, 9:50 AM
>> Nope
>> MON=0
>> the mystery continues
>> nu4c
>>
>>
>>
>>
>> ________________________________
>
>> Could this be the Monitor Gain?
>>
>> Try pressing the bottom right knob to the left of the VFO
>> for about a half
>> second (HOLD time), the VFO B area should say "MON xx"
>> where xx is a number,
>> and rotate the knob to a lower setting. This knob is also
>> used for
>> compression, transmit power, etc.
>>
>> 73 de Dick, K6KR
>>
>>
>> -----Original Message-----
>
>>
>> Hi folks
>> I need a little help. I am using the K3 on PSK a lot. I
>> turn the audio gain
>> to
>> zero and that mutes received audio. However, I cannot find
>> a way to mute the
>>
>> transmit audio (annoying whine). I have rear and reread the
>> manual and
>> cannot
>> find any help.
>> Does anyone know how to mute transmit audio on PSK?
>> tu
>> Paul, NU4C
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>