[Elecraft] K3 / 6meters / line out

[John Ragle]

When using digital modes (excepting CW) I run my K3/100 with a SignaLink 
USB. Normally I don't use digital modes on 6 or 2 (I have a K144XV 
installed), but recently I installed the WSJT 9 Suite and noticed the 
following peculiarity -- on 6 meters only -- which is also audible 
through the speaker. There is considerably less audio on 6 meters for a 
given set of front-panel settings than on all the other bands.

I normally run LINE OUT = 08, but on 6 meters, to the WSJT 9.02 suite, 
to get the ~0 dB reading I have to run LINE OUT around 30-35. On 2 
meters the LINE OUT setting is the usual LINE OUT = 08.

This is not a problem, but it does have me a bit puzzled. Any 
suggestions out there? I have doubtless overlooked some CONFIG setting?

John Ragle -- W1ZI