[Elecraft] k3 sub receiver ant selsction

[Cady, Fred]

Hi Luca,
Here is a picture showing what you want to do.
http://www.ke7x.com/home/guide-to-the-k3/main-and-sub-rx-antenna-switchi
ng
It shows the Main Rx connected to ANT1 and the Sub Rx connected to ANT2.
You must have Config:KRX3 Ant=ATU. Then turn Sub On (tap SUB) and then
either RX ANT or Hold BSET and then tap ANT.
When you have this configuration you can switch the antennas back and
forth by tapping ANT.

Fred Cady
fcady at ieee dot org  

> -----Original Message-----
> From: elecraft-bounces at mailman.qth.net 
> [mailto:elecraft-bounces at mailman.qth.net] On Behalf Of iz0fyl
> Sent: Saturday, December 18, 2010 9:47 AM
> To: elecraft at mailman.qth.net
> Subject: [Elecraft] k3 sub receiver ant selsction
> 
> 
> Hi folks
> just a question.
> I' don'nt understand the selection scheme of the sub rx.
> In the figures of the manual seems that is possible in the 
> aux rreceive
> using ant1 on main ant ant 2 on sub.
> the question is: isit possibile to reiceive on main rx the 
> anti1 signal and
> anthe sub rx the antenna 2 signal?
> I tried on my k3 but I hear the ant1 in both the receivers
> thanks
> luca
> 73 de iz0fyl
> -- 
> View this message in context: 
> http://elecraft.365791.n2.nabble.com/k3-sub-receiver-ant-selsc
tion-tp5848447p5848447.html
> Sent from the Elecraft mailing list archive at Nabble.com.
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>