[Elecraft] Data A filter questions

[Don Wilhelm]

  Wes,

Can you toggle between HI/LO and SHIFT/WIDTH when in SSB mode?
I can shift between the two in all data modes except FSK D where they 
stay in SHIFT/WIDTH.

Just wondering if your K3 is broken.

73,
Don W3FPR

On 12/16/2010 3:29 PM, Wes Stewart wrote:
> Don, and I'll reply to Monty here too,
>
> There is no question that I'm in Data A and my HI and LO controls do not function.  I seldom use PSK, I prefer RTTY, but I'm sure that this didn't happen in the past.  Just for giggles I rolled back my firmware to 4.0 sumptin' and I had the same issue.
>
> I generally leave the VFO set for example to 14.070 and click tune on the waterfall, but use HI and LO cut to select the signal of interest.  As it stands the SHIFT range is so limited that I can't isolate lower tones.
>
> Wes
>