[Elecraft] XG2 Frequency Accuracy

[David Gilbert]

Yeah, I understand that.  I was just wondering how close they might be 
since I don't have a clue what the tolerance is of the crystals used by 
Elecraft.  Specifically, I was wondering if they would be close enough 
(typically) to use for in-band IMD tests as a function of AGC settings.  
Or at least close enough that whichever one was higher in frequency 
could be easily padded down to within a few tens of Hz or so of the other.

73,
Dave   AB7E



On 12/11/2010 7:22 PM, Don Wilhelm wrote:
>  Dave,
>
> The frequency accuracy of the XG2 will vary with the individual 
> crystals.  It is not specifically for frequency accuracy, but for 
> level accuracy.
>
> In other words, I would not depend on the XG2 for any sort of 
> frequency calibration unless you measured the output of a particular 
> one with a calibrated frequency meter.
>
> 73,
> Don W3FPR
>
> On 12/11/2010 9:00 PM, David Gilbert wrote:
>> Does anyone know the typical frequency accuracy of the XG2?  If I had
>> two XG2's, what would be the typical separation in frequency between the
>> two of them at the 14060 setting?
>>
>>
>