[Elecraft] An AGC story

[David Gilbert]

Nice program, but it doesn't run with LP-Bridge if I want to have more 
than one application (N1MM, CW Skimmer, K3_EZ, etc)  interfacing with my 
K3.  It is fine for simplifying the changing of AGC settings, but not on 
the fly during a contest.

Dave   AB7E



On 12/9/2010 8:18 PM, Sam Morgan wrote:
> check out K3_EZ
> http://home.roadrunner.com/~n2bc/SW.htm
> then connect and check out the AGC Setup page
>
> GB&  73
> K5OAI
> Sam Morgan
>
> On 12/9/2010 8:49 PM, David Gilbert wrote:
>> OK, but that still doesn't address decay or slope ... parameters I might
>> want to quickly change dependent upon the amount and type of band noise
>> (such as when changing to the low bands or when thunderstorms are
>> active) or the number (not only the level) of signals (pileup or QRM).
>>
>> I still say a few re-callable combinations of AGC settings would make
>> sense, even if they had to be initially configured only through the
>> CONFIG menu.
>>
>> 73,
>> Dave   AB7E
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>