[Elecraft] new firmware release

[Dick Dievendorff]

Just a wild guess, but are your filters enabled for the mode you're using?

Using the K3 Utility's Configuration tab, Configure Crystal Filters, check
the rows titled "CW Enable", "LSB enable", etc.  These allow the filters to
be used for receive for the various modes.  Your 400 Hz filter needs to be
checked for it to be used for receive.


73 de Dick, K6KR




-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of wf4o
Sent: Tuesday, December 07, 2010 1:54 PM
To: elecraft at mailman.qth.net
Subject: [Elecraft] new firmware release


 I'm new to the K3 and so my settings may be faulty, buy here goes. I
downloaded and installed the latest firmware today without problem. My
problem is that when I  narrow my width to 0.5 I immediately lose all audio.
I have a 400 Hz filter installed. I only regain audio with widening the
width greater than 500 Hz and by turning off the AGC. This occurs with or
without the APF being engaged. Also with APF engaged and with or without AGC
I lose all audio and get strong clicks when adjusting the width and APF. Am
I missing something in my setup?
-- 
View this message in context:
http://elecraft.365791.n2.nabble.com/new-firmware-release-tp5813395p5813395.
html
Sent from the [K3] mailing list archive at Nabble.com.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html