[Elecraft] P3 Questions

Robert Bajuk rbajuk at gmail.com
Sun Dec 5 08:50:19 EST 2010


>From the P3 instruction manual:

When used with a K3, this power may be taken from the 12VDC OUT jack on the
K3 rear panel. The K3 is capable of supplying power to both the P3 and the
Elecraft PR6 six-meter preamplifier at the same time if 12VDC or greater is
supplied to the K3’s power connector.
Lower voltages at the K3 connector will cause the total current required by
the P3 and PR6 to exceed the 500 mA limit from the K3’s 12VDC outlet.

P3 requirements:
Power: 10-15 VDC is a standard 2.1 mm barrel connector for a 10-15 VDC
supply capable of delivering up to 0.5A.

73 Robert, s57aw

2010/12/5 Mike <nf4l at nf4l.com>

> I don't have a P3, so I don't know what it's power requirements are, but
> you're going
> to have to have a power supply anyway for the K3......
>
> 73, Mike NF4L
>
> On 12/5/2010 8:23 AM, pastormg2 at verizon.net wrote:
> > I am condidering a purchase of a P3 with my k3. Do I understand correctly
> that I would need an additional power supply for the P3?  Or would I be able
> to connect it to the power jack on back of the k3 for power?  If I need an
> addiitonal power supply that's going to make the equipment jammed packed.
>  But I also read on the reflector that the power jack on the back of the K3
> doesn't have sufficient amps to run the K3.  Any advise would be greatly
> appreciated.  Mark KB3Z
> > ______________________________________________________________
> > Elecraft mailing list
> > Home: http://mailman.qth.net/mailman/listinfo/elecraft
> > Help: http://mailman.qth.net/mmfaq.htm
> > Post: mailto:Elecraft at mailman.qth.net
> >
> > This list hosted by: http://www.qsl.net
> > Please help support this email list: http://www.qsl.net/donate.html
> >
>
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>


More information about the Elecraft mailing list