[Elecraft] Handle replacement on K3

[Bill W4ZV]

Jon Zaimes AA1K wrote:
> 
>  The side panel did come off OK by itself, and the nut quickly dropped 
> out onto the work table. But no sign of the washer! I'm sure it had one 
> on when I built the radio, so I'm shaking the radio and searching for it 
> but so far to no avail. I assume it got stuck somewhere inside. Took the 
> top off too but still haven't spotted it. Perhaps it fell out one of the 
> air vents on the top during recent transit but I doubt it.
> 

Check the speaker magnet.  If you turned the unit upside down it might have
landed there (happened to me once).  I'd not turn the K3 on until you find
that washer!

73,  Bill 

-- 
View this message in context: http://elecraft.365791.n2.nabble.com/Handle-replacement-on-K3-tp5449432p5449545.html
Sent from the Elecraft mailing list archive at Nabble.com.