[Elecraft] Err 12V

[Brett Howard]

Check the crimp connections on the spades that connect to the circuit
breaker...

~Brett (N7MG)

On Sat, 2010-08-21 at 20:55 +0000, Paul Ormandy ZL4PW wrote:
> Hi all,
> 
> Yesterday, the K3 threw up the "Err 12V" error and bypassed the KPA3 
> module. The circuit breaker didn't pop and I was able to power off and 
> increase the power back up.
> 
> This was happening on PSK with 50W and RTTY with 100W.
> 
> I have yet to try digi modes in anger again today without first getting 
> some feedback. I had close to zero AGC/compression when this occurred.
> 
> Any suggestions will be most welcome.
> 
> Regards,
> 
> Paul
>