[Elecraft] Is there a an external signal on the K3 for ANT1/ANT2

[Guy Olinger K2AV]

Thank you.  I thought something was in there someplace.  It will be
harder to get this into a computer program and the computer program is
easier to mess up.  The menu entry will be available for anyone's K3
that is in use.  Splendid.

How about getting Opposite ANTx RX OUT to the back panel?

73, Guy.

On Sat, Aug 21, 2010 at 2:02 PM, Wayne Burdick <n6kr at elecraft.com> wrote:
> Guy,
>
> You can use a computer to poll for antenna select status using the "AN;"
> command. This will tell you which TX antenna is in use.
>
> If you don't have a computer in the system, you can use the "DIGOUT1" menu
> entry to obtain an antenna 1/2 indication on the DIGOUT1 pin of the ACC
> connector. DIGOUT1 is configured in the menu, and is per-band/per-antenna.
> For example, on each band you could set it to OFF (floating) for ANT1 and ON
> (0V) for ANT2.
>
> 73,
> Wayne
> N6KR
>
>
> Guy Olinger K2AV wrote:
>
>> Questions:
>>
>> I may be looking for something that's right under my nose, but I've
>> been digging and can't find it...
>>
>> ***>>> Is there a way in the various outputs to tell whether the radio
>> is transmitting on ANT1 or ANT2.
>