[Elecraft] P3 or KRX3

[David Gilbert]

Keep in mind that you can do point/click freqeuncy changes from the 
bandmap in certain logging programs.  Both N1MM (contesting) and 
Logger32 (general logger) offer rapid QSY that way .... I assume others 
do as well.   If you spot a frequency of interest on the Rocky display, 
you could do the actual QSY from the logger bandmap.  I've sometimes 
even loaded in dummy callsigns every few KHz  on the bandmap so that I 
can just step through them for QSY.

73,
Dave   AB7E



On 8/16/2010 5:16 AM, Bill Davis Jr wrote:
> Rocky software is much better than PSDR for weak sig detection, but you loose the Point and Click control of the K3. So for the stuff below the noise I stop PSDR and activate Rocky. Since most of my opeartions are weak signal I run Rocky and operate the K3 in a normal manner. For CW Rocky is fantastic. With 96Khz soundcard setup max resolution is about 15Khz for full width on my monitor.
>
>