[Elecraft] K3: Need help loading new firmware

[WILLIS COOKE]

You also need to be sure that the K3 and the computer are set to the same baud 
rate.
 Willis 'Cookie' Cooke 
K5EWJ 




________________________________
From: Jay <Livn2good at qwest.net>
To: elecraft at mailman.qth.net
Sent: Fri, August 13, 2010 11:38:33 PM
Subject: [Elecraft] K3: Need help loading new firmware

Gave up trying to get the big computer (Vista) to talk thru COM Ports.  
It just won't find one.....So went to my old Laptop w/Vista and it 
picked up Com3, said it was communicating so I clicked on "Send All New 
Firmware to K3".  It says "Sending firmware file hmcu0405.hex to 
MCU"...... That was half hour ago....Still just nothing happening.  
Should my K3 be on or off for this?  Think I only did this once before 
when I built it years ago.  P3 is on the way and I'm told I have to 
upgrade the firmware.    W6JDB
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html