[Elecraft] P3: a modest proposal for QSY

[Joe Subich, W4TV]

 > Larry - K2GN wrote:
 >>
 >> Solution:  Use the MKR A to get to the high side of the freq,

And if you want to completely automate it from the P3, write
a macro that turns on the K3 auto tune (tap CWT) then taps Spot
and turns off auto tune (tap CWT).  Store that to one of the
P3 Function buttons ....

If the P3 Programmers Guide were available, the macro could be
extended to include the P3 "tap" function and turning off the
marker when finished.

73,

    ... Joe, W4TV


On 8/11/2010 2:15 PM, Bill W4ZV wrote:
>
>
> Larry - K2GN wrote:
>>
>> Solution:  Use the MKR A to get to the high side of the freq,
>>
>
> This is key and I had forgotten because it had become second nature.  Since
> the MKR trace is 2 pixels wide, it cannot be placed exactly on a 1 pixel
> wide signal.  Apparently Alan chose to set it this way which is why I want
> him to go to 1 pixel width (like the white Spectrum Center Line).  Meanwhile
> what Larry says is true...at least for UCW which is what I use.
>
> Graphically, it should look like this:
>
> MM
> S
>
> Not this:
>
> MM
>    S
>
> What I want is this:
>
> M  (i.e. 1 pixel)
> S
>
> 73,  Bill
>