[Elecraft] P3: a modest proposal for QSY

[Bill W4ZV]

Bob Cunnings wrote:
> 
> Yes, Ref Cal has been performed on both K3 and P3. The issue is ergonomic.
> 

Another thing I do is to align the Spectrum MKR with the Waterfall (no MKR). 
The Center Line in the Spectrum Display interferes with the signal and MKR
so it's easier to align if you use Split Display mode with Spectrum MKR only
and align to the signal in the Waterfall immediately below.

As I said before I also hope for some sort of Snap Tune, but I can do much
better than +/- 100-200 Hz with the current setup.

73,  Bill

P.S.  Depending on which firmware rev you have there may not be a Waterfall
MKR available.  There is in beta 00.30 but I don't use it for the above
reason.

-- 
View this message in context: http://elecraft.365791.n2.nabble.com/P3-a-modest-proposal-for-QSY-tp5410950p5412535.html
Sent from the [K3] mailing list archive at Nabble.com.