[Elecraft] P3 Manual Rev A3 changes

[Ron D'Eau Claire]

There are some other changes in the operating section. Here's a summary of
the significant changes:

1) Incorporated outstanding errata A2-1.

2) Integrated Appendices into main document to allow better
cross-referencing between sections.

3) Added "Servicing" section including one page of notes for -F owners about
how to remove/replace individual boards, how to clean the bezel safely and
one page of detailed instructions for removing/replacing the LCD panel (pgs
37, 38). 

4) Added instruction to perform frequency calibration for best accuracy to
Quick Start Basics (pg 5).

5) Added explanation of changing baud rates to Rear Panel connectors/RS232
on page 13

6) Edited first para under "Programmable Functions" to note that FM REV
cannot be assigned to a key.

7) Fixed typo in the last line of the first para under "Using Markers"
changing "upper sideband" to "lower sideband". 

8) Added note to warm up transceiver and P3 for 30 minutes before doing the
calibration (pg 19). 

9) Under "Menu Functions" , "DispTest" changed instruction to read "Tap MENU
to exit."

Ron AC7AC

-----Original Message-----

Took a quick look at the rev A3 manual after using rev A2 last night to
assemble and test the P3.  As far as I can tell, the only difference is the
addition of a "Servicing the P3" section at the end of the rev A3 version.
Talks about removing the covers, cleaning the bezel, replacing the display,
etc.

73   Craig  AC0DS