[Elecraft] P3 Owner's Manual

[Ron D'Eau Claire]

Hi Phil:

Here are the changes:

Corrected Resolution Bandwidth to "Span / 450, 8 Hz minimum" on page 8. 

Added Operating Tip to Parameter Initialization on pg 21 emphasizing that FN
key assignments are erased and MENU entries are returned to the defaults
shown on page 20. 

Fixed typo in fourth bullet on pg 21. 

Moved knob from Front Panel envelope to the Chassis Hardware envelope in the
Parts List pg A-2.

Added instruction to gently push the LCD panel into the rubber matrix as
needed so it is fully seated Assembly Procedure pg B3. 

Added specific instruction to place the serial number label on the rear
panel under the IF IN jack.

Ron AC7AC

-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Phil Hystad
Sent: Friday, August 06, 2010 8:32 PM
To: Elecraft Reflector
Subject: [Elecraft] P3 Owner's Manual

I read the owner's manual that came with my P3 but then realized that it had
been updated.  My original was A1 and I just downloaded the A2 copy and I am
printing it.  I also downloaded the errata to A2.

So, does anyone know what changed between A1 and A2?

73, phil, K7PEH

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html