[Elecraft] K3 #4536 arrives

[Mike]

  Congrats, Bill. After you finish the build, then comes the real excitement.

I had the same issue with the phone jack. The common wisdom was that the board wasn't 
seated properly, which was not true. I just let it rattle, with no known ill effects. 
When I did the DSP board swap I snugged it up with pliers and didn't break anything.

73, Mike NF4L

On 8/5/2010 2:31 AM, Bill Conkling wrote:
> Hi,
>
>
>
> My K3/10  arrived today and I have 10 hours in so far and am  going to bed.
> Next step is mouthing the speaker.  My fingers are not as nimble as they
> used to be but so far, I've only dropped three items, a screw, and two
> washers.  All retrieved.  The resistance checks were ok and the power-up
> went well.
>
>
>
> The only concern now is that phone jack doesn't pull up tight to the front
> panel and the washer rattles.
>
>
>
> Off to bed, get up in the morning and finish up.
>
>
>
> :Looks real nice so far.
>
>
>
> ...bc   nr4c
>
>
>
>
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>