[Elecraft] K3 communcation issue solved!

[K4IA at aol.com]

I often find the true solution is the simplest.  Occam's Razor 
 
k4ia

In a message dated 8/3/2010 3:47:13 P.M. Eastern Daylight Time,  
aldermant at windstream.net writes:
Thank you to those who have been trying to  help me to get my new K3 to talk
with N1MM. That issue is now solved.
It  wasn't until I thought I had checked and rechecked all configurations,
both  in N1MM and in the K3, that I finally became convinced it was not  a
software/firmware issue. In checking my serial cables, I found the  DB-9
connector to the K3 had slipped partially out of the K3 connector. I  simply
reseated that connector (AND used a screw driver to fasten it to the  K3 and
the K3 immediately started communicating with N1MM again.
I do  appreciate everyone offering me very well thought out suggestions to
solve  this problem.
Thank you all again
73,
Tom -  W4BQF






______________________________________________________________
Elecraft  mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help:  http://mailman.qth.net/mmfaq.htm
Post:  mailto:Elecraft at mailman.qth.net

This list hosted by:  http://www.qsl.net
Please help support this email list:  http://www.qsl.net/donate.html