[Elecraft] K3 communcation issue solved!

[Tommy Alderman]

Thank you to those who have been trying to help me to get my new K3 to talk
with N1MM. That issue is now solved.
It wasn't until I thought I had checked and rechecked all configurations,
both in N1MM and in the K3, that I finally became convinced it was not a
software/firmware issue. In checking my serial cables, I found the DB-9
connector to the K3 had slipped partially out of the K3 connector. I simply
reseated that connector (AND used a screw driver to fasten it to the K3 and
the K3 immediately started communicating with N1MM again.
I do appreciate everyone offering me very well thought out suggestions to
solve this problem.
Thank you all again
73,
Tom - W4BQF